01
Modular Jack Ready solution
The structure is designed as a fixed base with mounting points for the possible addition of mechanical components. Expansion can therefore be prepared during the initial power-plant design.
Czech engineering
Designed for straightforward installation and future development
The primary structure enables a standard fixed configuration while creating the technical basis for a tracking system to be added later.
02
One drive for multiple panels
Mechanical connection of rows by rods reduces the number of drives needed and creates a repeatable principle for assembling a larger power plant.
03
Solutions for flat roofs
The mounting layout can be adapted to the available area, panel dimensions and required project output. The continuity of individual mechanical components is important.
Mounting-system principle
One foundation, well-considered continuity
The mounting principle works with clearly defined parts that are technically connected to one another.
Fixed base
The structure creates a stable panel layout for a standard installation.
Prepared points
Mounting connections leave room for later technical expansion.
Controlled movement
After adding mechanics, a drive and controls, the system can be expanded with panel tilt adjustment.
Low roof load
Near-zero wind resistance enables installation with minimal load, so the system can also be used on roofs with lower load-bearing capacity where standard PV could not be installed.
Choose an option